Arduino 1mhz oscillator - Tuning ATtiny internal oscillator - Becoming Maker
gpsdo GPS Disciplined Oscillator Project (Arduinobased, 10MHz, 1MHz, 10kHz outputs )
From Arduino to a Microcontroller on a Breadboard. you can configure the ATmega328 to use its internal 8 MHz RC oscillator as a clock source instead.
External Crystal Oscillator. Topic locked. The internal oscillator works at 1MHZ while an external can function at much more The Arduino is a nice.
1 MHz Clock Signal According to the data sheet I need to supply the DEI1016 chip with a 1 MHz clock signal. The Arduino uses 16 MHz oscillator, one would think one.
BOB: This is a breakout board for the DS1077 is a dualoutput, programmable, oscillator. Contains a filter capacitor and all 8 pins broken out to a 0. 1 header.
Build your own DIY Arduino board with only one passive component, it is very easy and simple. This is probably the most minimal ATmega328 based Arduin